RISE UP DIED FLASH

 HOW TO RAISE DEAD FLASH USING CMD. (command prompt)

Insert a damaged flash into your computer and make sure it is read, and do not burn any device other than your damaged flash. After that follow the following steps: -

1. Open CMD by pressing start key + R then type cmd and then press Enter CMD will open.

2. Type in cmd diskpart then press Enter, it will ask you to accept by clicking OK then proceed to follow the steps…

3. Enter the list disk then press Enter, there you will see the local disks of your computer along with the flash you burned.

4. Check your flash number then type select disk then skip space write the disk number where your flash is then press Enter, it is usually disk 1 so you will type select disk 1.

5. After that type clean then press Enter.

6. Type create partition primary then press Enter.

7. Then type active and press Enter.

8. After that you will type select partition 1 then press Enter.

9. The end will end by typing the format fs = fat32 then press Enter.

When you have finished following all these steps, wait for a while until your flash is 100% full and you can extract it and use it.

If there is a place I do not understand please ask by leaving a comment when I see it I will answer you.

Thanks for your attention.

Thanks for visiting this page.

Thanks for reading this post.